ACCELERATOR CONTROL 6H – 5
4JA1TC, 4JH1TC/LHD
PTW46BMF000101
6H – 6 ACCELERATOR CONTROL
Removal
1. Disconnect the accelerator control cable from the
accelerator pedal and dash panel.
2. Remove the cable clips.
3. Remove the accelerator control cable from accelerator
control cable bracket.
1) Slide the lock in direction A
2) Rotate the ratchet ring in undirection an arrow 90°.
4. Remove the accelerator control cable from the throttle.
Inspection
Check the following items and replace the control cable if
any abnormality is found.
· The control cable should move smoothly.
· The control cable should not be bent or kinked.
· The control cable should not be damage or
corrosion.
RTW46HMH000201 Installation
1. Install the accelerator control cable to accelerator
control pedal dash panel.
2. Install the accelerator control cable to throttle.
Attach T-END and inner cable to throttle cam of
engine.
3. Install accelerator control cable to accelerator bracket.
1) Rotate the ratchet ring in direction an arrow 90°
until both white marking are aligned.
2) Confirm marking of outer cap must be upper side.
3) Slider the lock in direction B.
4) Confirm ratchet ring is locked.
4. Install the cable clips to accelerator control cable.
NOTE:
Confirm that the throttle (engine side) is at full stroke
when the accelerator pedal is at full stroke.
No. TF4JE-WE-0431
The words you are searching are inside this book. To get more targeted content, please make full-text search by clicking here.
ISUZU Service manual 4JA1-4JH1-TC
Discover the best professional documents and content resources in AnyFlip Document Base.
Search
ISUZU Service manual 4JA1-4JH1-TC
- 1 - 50
- 51 - 100
- 101 - 150
- 151 - 200
- 201 - 250
- 251 - 300
- 301 - 350
- 351 - 400
- 401 - 450
- 451 - 500
- 501 - 550
- 551 - 600
- 601 - 650
- 651 - 700
- 701 - 704
Pages: