F!'C}LITHI{NiH
M A L,.\YS IA-
PORT DICKSON
MECHANICAT ENGI NEERING DEPARTMENT
JUNE 2O2O
DJJ1OO13 ENGINEERING DRAWING
PRACTICAL TEST 1: SECTIONAL VIEW
Name: Reg. Num:
PtOs: Apply appropriate techniques, resources, and modern engineering and lT tools to well-defined engineering problems, with an
awareness of the limitations.
cLO2: Construct the technica I drawing and 2D CAD drawing according to the engineering drawing standards.
CLS3a: PracticalSkills
CLS3b: lnterpersonal & Communication Skills
lnstructions:
1. From the figure below, construct the following drawing: (P3) (50 marks)
a. Top View (with cutting plane line)
b. Front View (with full sectional view - cutting plane A-A)
c. Side view
2. Time given: 30 minutes
A
*(All dimension in mm)*
Prepared by: Checked and Verified by:
.,--- l-H. Consistent with:
tuI trriiu.i tuiAD i i i Liri i Bli,t ZAI D r AST
PensYareh r CIST
. BlodJn's Taxonomv Domain
(@Jebatan Kejurutoraan fulekanikal
YUSOI
[ectu rer/ Course Coordinator K€tua Proglem
.l auaiotamn'.rriiiiiit't.P'aoirot ,Dk[l:tl9onn'*'
Ncg.ri S€mblhn