Color Project 2017 Jordan W.

Color Project

Section 3, Highlights

-Prior to applying bleach,
grooming hair, and having
hair clipped into sections.

-Used 20 volume developer
mixed with bleach. Also
added matrix color boost
in purple to tone as the
hair processes.

-Let process for 20-25min,

Shampoo/Blow-dry to get
finished result.

Section 2, Filler

Filling the blonde prior
to color application,

-Applied filler: 07CB
Spicestone with shades
EQ gloss processing
solution.

Let process for 5-10min

Section 2-Continued

Applied 5NN, and let
process for 30m. Once
Shampoo/Blow Dry I
then did another
application to fill in
any dry spots missed
from first
application, then
again resulting in
shampoo, blow-dry,
and style.

Section 1, Gray Coverage

Color: ¼ of 3NN & ¼ 5NN
with 20 oz. Developer

Hair is clipped in to
sections dividing the
quadrants, then going
through and taking ¼ sub
sections all the way
through (top –bottom)
applying color from base
of scalp to the ends,
towards end of
application (bottom of the
quad) going back through
and checking for any dry
spots left or color that
had not been properly
applied.

Let color process for 45min

Section 1, Continued

-Finished result of gray
coverage, covering a high
resistant salt/pepper gray
mix and then applying,

-3NN +5NN to get the
level 5 brown to match the
other quads to make an
even color throughout.

Section 4, Demi

Permanent hair

color correction

-Demi Perm, using the
shade chicory/ ½ oz.
with Shades EQ gloss
processing solution ½
oz.

-Going through with ¼
sub sections, and
applying color evenly
through each layer.
Once reaching to the
bottom of quad going
back through, and
checking for dry spots
prior to finishing
application.

-Let process for 25-
30min

Shampoo/ Blow-dry as
follows

Hair Color

Correction

PART 1: this is the first
step of getting to the
color goal, by pre
lighting with soap caps
by diluting the
integrity of the bleach
through (developer,
bleach, shampoo mixed
together) and by
lifting the hair through
phases rather over
processing the hair
through various
applications.

Continuation of

Color Correction

-After 2-3 soap caps the
color lifted to a copper
blonde and I then
proceeded to giving her an
angled long bob with an
undercut.

Undercut Bob

-Listed are a few more
up-close pictures of the
undercut through the
hair transformation.

- I went and sectioned
the hair in a “V” shaped
style. Went in with a 3
underneath and tapering
it down to a 2/Borderline
1- 1 &1/2.

-Then ending the
undercut with a cleanup
along the kneckline.

Bob Process

-The bob that is shown I first
went through with a solid
pony tail to be cut off.

-Since we were going to do a
full bleach process I figured
it would be best to leave a
little bit more hair then I
wanted to cut off but
cutting off hair that was
definitely of no use since a
bob was wanted.

-I then started taking
sections and doing a 45
degree cut to give the
dramatic angle that is shown
on the sides as well as some
point cutting to give a softer
graduation, while still
maintain some length.

Highlights/Slicing

Bob Continued.

-Here I foiled pieces of hair
throughout ranging from
slice method to get the
chunky blonde as well as some
weaving techniques around to
get the blended look of blonde
mixed with the lifted hair
color.

-Products Used-

30vol Developer, with bleach

-Went through whole head
and did section by section to
lift to maximum by safely
doing so without
compromising the integrity
of the hair.

End Result of Blonde

-The finished result from
prior blonde application.

-I then go through with
another application trying to
ensure that all blonde pieces
are the lightest of blonde

-Using a 40 Dev, with bleach
going section by section
throughout the whole head to
ensure the integrity of the
hair as well as an even lift.

Finished Result

-These pictures reflect the
finished result, which is a
high level blonde with some
darker pieces for dimension. –

-Following the bleached/sliced
blonde. I will now go through
with my Color Pigment.

PRAVANA NEON

-Prior to application, I did a
strand test on the mid back
of the manikin head.
Resulting in the color taking
vibrantly, I proceeded with
color application.

-When applying color to the
hair being that its pigment
and not needing a developer I
just slapped it on all over
concentrating mainly at the
top and everywhere else
needed.

SHADOW ROOT

-Following through with
Neon application, I decided
to put 2n as a shadow root
on the roots acting as a
natural shade and to give
dimension through
transition.

-Foiling from the undercut
to give depth underneath
the bob, bring in up into
the NEON to give a multi-
dimensional look with
accenting pieces
throughout.

-Repeated this process 1-2
times, the first for
placement and the second
for filling in where gapes
were made and or bleeding
with color.

Neon Shadow Root

The final pictures of the hair
transformation will go as
listed.

-The finished product from
prior shadow root, I lastly
went back in one more time
with the pravanna neon to
boost up that neon that had
been lost prior to color/wash.

-Lastly Round brushed/ curled
the manikin with a 2 in
barrel iron giving a soft but
edgy look resulting in my
finished color project.