Uptown Fire Pit Table - NorthlineExpress

Uptown Fire Pit Table

Installation Instructions

1|Page

NorthlineExpress.com www.NorthlineExpress.com Toll-Free 1-866-667-8454

Contents

Contents……………………………………………………..2
Required Tools…………………………………………..3
Placing and assembling the Table.……4
Gas Connection………………………….…………….5
Igniter Installation…………….………………………...6
Locating Propane tank……………………………8
Finishing Touches……………………………………….9

90218:A 2.24.2012 2|Page

NorthlineExpress.com www.NorthlineExpress.com Toll-Free 1-866-667-8454

Required Tools

 Utility Knife

To cut and remove packaging

 2 Open Ended Wrenches

To make gas connections

 Leather Gloves

To protect hands from rough edges found
on the coffee table.

 One (1) AAA Battery (not included)

Required for piezoelectric igniter
installation.

 Do not attempt to perform

installation by yourself. This fire
pit table is constructed of steel
and heavy stone products.
Have at least one other
person help you.

3|Page

NorthlineExpress.com www.NorthlineExpress.com Toll-Free 1-866-667-8454

Placing and Assembling the Fire Pit table

1. Remove access door from box and set aside.

2. Remove all components from packaging.

3. Move the base sections without door to desired
location and set into place spaced approximately
21” from each other.

4. When locating your coffee table, refer to the
Crystal Fire manual and maintain clearance to
combustibles.

5. Assemble as shown below.

Igniter on side
closest to tank base

4|Page

NorthlineExpress.com www.NorthlineExpress.com Toll-Free 1-866-667-8454

6. Insert supplied sheet metal screws into the locations
shown by arrows below. This secures the granite tile top
to the base.

Align smaller base with concrete top as shown by
dashed line.

Read and understand your Crystal Fire owner’s manual
before beginning burner hookups or using the device.

5|Page

NorthlineExpress.com www.NorthlineExpress.com Toll-Free 1-866-667-8454

Gas Connection

1. Lift burner out of top and set aside
2. Connect the incoming gas line and flexible

metal gas line from the valve to the underside
of burner, running flex hose through access
hole as shown before connecting line to
valve. It is not recommended to use Teflon
tape or pipe dope on the connection to the
valve with flare fittings.
 LPG installations use the hose and regulator
provided with the burner.
 For Natural Gas hookup information and any
other info not listed here consult your Crystal
Fire owner’s manual.
 Consult Crystal Fire manual for proper orifice
size for the chosen fuel type before attaching
flex line to burner and tightening securely.

6|Page

NorthlineExpress.com www.NorthlineExpress.com Toll-Free 1-866-667-8454

Igniter Installation

(If your igniter only has one port on the back, please ignore
instructions for grounding. Your igniter is a self-grounding
model)

1. Make sure the valve is in the OFF
position

2. Unscrew sparker cap and hex nut.
Install as shown below.

7|Page

NorthlineExpress.com www.NorthlineExpress.com Toll-Free 1-866-667-8454

3. To properly install ignition system, a spark and ground wire
need to be attached to the igniter box.
 Thread black spark wire which hangs from burner
through access hole alongside metal flex-line and plug
into sparker box.
 Plug the included grounding wire into the back of the
sparker box. The free end of the grounding wire should
be secured to the underside of the burner by loosening
one of the nuts on the end nearest to the control panel
and inserting the plug as shown before re-tightening
the nut.

 Test system by depressing the button on the igniter. A
continuous repeating spark between the igniter
electrode and spark-receiving probe means everything
is connected properly. Consult the troubleshooting
section if spark is weak, intermittent, or not present.

4. Once ignition system is grounded and gas
connections are secured and checked for
leaks, set the burner back into its original
position if you haven’t already done so.

8|Page

NorthlineExpress.com www.NorthlineExpress.com Toll-Free 1-866-667-8454

Locating your Tank

1. Your tank should be positioned so that
the fuel can be shut off after each use.

2. Slide the tank into the framework past
the line shown below. This is to allow
the door to close completely.

3. Confirm all hoses are clear and not
touching the burner.

Position tank behind this line

 Install door by setting the bottom on the catching hooks first and
then closing. Magnets in the table will hold door closed.

9|Page

NorthlineExpress.com www.NorthlineExpress.com Toll-Free 1-866-667-8454

Finishing touches

Once fire pit is set up and in the desired position,
scatter decorative glass on burner surface forming
an even layer of beads.

 DO NOT BURN WITHOUT GLASS OR OTHER
DECORATIVE SUBSTRATE PRESENT

IMPORTANT

Please consult your Crystal Fire instruction manual for detailed
instructions and important information related to hooking up your
linear burner, including safety information, proper tightening of
connections with two wrenches and full burner setup and lighting
instructions.

DO NOT ATTEMPT TO INSTALL CF-1224 BURNER WITHOUT FIRST
CONSULTING THE MANUAL. IF YOU ARE UNSURE OF HOW TO
COMPLETE THE STEPS OUTLINED, CONSULT A QUALIFIED
TECHNICIAN

WARNING

After consulting the manual and following instructions, remember; before operating,
all gas connections must be fully checked for leaks

10 | P a g e

NorthlineExpress.com www.NorthlineExpress.com Toll-Free 1-866-667-8454

Warranty: Fire pit tables are covered under a 1-
year manufacturer’s warranty. Please visit
http://www.outdoorrooms.com/warranty-form
to register your product.

11 | P a g e

NorthlineExpress.com www.NorthlineExpress.com Toll-Free 1-866-667-8454

© 2011 The Outdoor GreatRoom Company

2015 Silver Bell Road • Suite 195 •
Toll Free: 1-866-303-4028

12 | P a g e

NorthlineExpress.com www.NorthlineExpress.com Toll-Free 1-866-667-8454