NEW PROPYLENE BEVEL CUTTING TORCH - Gas Innovations

APPROACHING AN

NEW PROPYLENE BEVEL CUT

BEVEL CUTTING PARAMETERS: Large S
Propylene was 15 psi, preheat oxy was ab
around 95 psi. 4 inch thick plate, the beve
depth, and travel was about 8 i.p.m. It wa

REPLAC

OLD INDUSTRY IN A NEW WAY IMPROVING GAS SALES

TTING TORCH

Steel Fabricator in East Texas.
bout 20 psi, and cutting oxy was
el measured 7.25 inches total
as beveled COLD.

EM300-2B

CES THE DUAL TIP BEVEL HEAD SET-UP

APPROACHING AN

Steel Casing Fabricator, New Ib

CASING 72” x 1-3/4” thick PROPYLENE FUEL GAS
They were using a Victor machine torch to bevel. Th
The EM300-4C did the job in 12 minutes on its first p
Gas. What an incredible labor savings!

OLD INDUSTRY IN A NEW WAY IMPROVING GAS SALES

beria, LA EM 300 TORCH BEVELING

S
his process took them approximately 35-40 minutes.
pass. Only using 65 psi oxygen 15 psi Propylene Fuel

APPROACHING AN

EAST TEXAS, drag crane base

DRAGLINE BASE PLATE – EM30

OLD INDUSTRY IN A NEW WAY IMPROVING GAS SALES

e plate 12” thick

00 TORCH PROPYLENE 12” THICK

APPROACHING AN

EAST TEXAS Pressure Vessel Shop
holes on the hillside to a maximum

Positioning & Automated Hole is first pierc
Circle Cutting Equipment.

Test Set-up 5 to
dow
the

28 FOOT PRESSURE VESSEL – EM

OLD INDUSTRY IN A NEW WAY IMPROVING GAS SALES

p, 5” wall thickness cutting spigot
of 10.5” EM Torch 300 tip.

ced using a magnesium cut rod & Oxygen

Finished Cut
No grinding

10.5” SLUG CUT OUT

o 10.5” cut looking
wn the side wall of
e cut

M300 TORCH USING PROPYLENE